|معلومات أخرى||Technical means data|
Manufacturer: NEW HOLLAND CNH BELGIUM N.V. B 8210 ZEDELGEM , BELGIA
Year of manufacture: 2006
Curb weight: 2240 kg
- width 2,0 m - robocza
- unloading ramp,
- net tying,
- Tyred copying wheels
- Automatic chain greasing.
The machine is set for harvesting green fodder and straw in small and medium farms.
Baling press NEW HOLLAND was given for recognition, it was in very bad technical condition, very dirty with postharvest leftovers, with mechanical damages.
Instruction manual and Technical/Movement Documentation were not presented.
Presented machine was incomplete - no press controller.
Year of production was set for 2006 based on the permanent indications on the unit rating plate.
Basic fittings - incomplete,
Hydraulic unit (pump, wires, engines) - complete, leaks were not stated,
Lacquer coating - of a yellow colour, with mechanical damages,
Liquid leaks - not found,
Machine efficeincy and completeness - there is necessity of verification in service conditions, mechanical damages on the whole surface of the press,
Fixing and conservation of the machine - not presented,
Machine identification documents - not presented,
Machine mileage documents - not presented,
Testing parts without load - no possibility to test in recognition conditions.
Body of a yellow colour with signs of mechanical damages on the whole surface.
LAcquer coating with exploitation signs - scrapes, mechanical damages.
Body parts qualified for repair/replacement:
- front cover - bent, broken off the hinges / qualified for replacement,
- support foot - bent / qualified for replacement,
- main hitch - bent / qualified for repair,
- rear cover - mechanical damage, material torn / qualified for replacement,
- upper pickup cover - bent / qualified for replacement,
- plastic PTO cover - broken / qualified for replacement,
- right side cover - bent / qualified for repair,
- left side cover - scratched / qualified for repair
- working mechanisms - very dirty with postharvest leftovers,
- wrapping chain beams - bent individual elements / qualified for verification and repair.
Damages and leaks of engines and work wires during the recogntion without test move were not stated.
During the recognition no damage to the electric unit were stated.
Basic machine accessories - incomplete.
Lacks in accessoreis:
- main controller.
PTO shaft was not presented.